Version 6.50.0.0 of Flex out now

A new protocol for Land Rover vehicles is now available on Flex: with this latest software update, you can program MD1CP007 engine units in Bench mode.

Connect your Flex to the ECU connector to unlock the full potential of Internal Flash and Internal EEPROM memories. Get started on optimizing the performance of vehicles like the Defender and Range Rover, and easily remove trouble codes from Bosch MD1CP007.

Please note: Flex V1 will soon be disabled. Upgrade to the incredible Flex V2 and install the new interface in just a few simple steps — your ticket to enhanced functionality!

*If your subscription is temporarily inactive, you can still use Flex V2. However, please note that the Datalogger feature and newly released protocols won’t be accessible until your subscription is renewed.

Some of the supported vehicles include:

• Land Rover Defender L663 3.0L MHEV 203PS Hybrid
• Land Rover Defender L663 3.0L MHEV 304PS Hybrid
• Land Rover Range Rover L460 3.0L MHEV 253PS Hybrid
• Land Rover Range Rover L460 3.0L MHEV 304PS Hybrid

This new protocol is available for these software packages:

• FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
• FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
• FLS0.10M – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Master
• FLS0.10S – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Slave
• FLS0.5M – SW Flex Full Master
• FLS0.5M – SW Flex Full Slave

Newly added protocols:

• (Bench)
• JLR Bosch MD1CP007 TC298 Read/Write/Checksum Calculation Maps, Read/Write Internal EEPROM

Reading Time: ~ 1 minute and 30 seconds Writing Time: ~ 1 minute

Bug Fix:

• Added new CRC type for PSA Continental SID80x
• Added new CRC type for VAG Bosch MD1CS004
• Added new CRC type for FCA Marelli MM10JA
• Added new CRC type for Mercedes Continental ACM2.1 D3

Software Improvements:

• Improved identification process on FCA Continental GPEC2

Click here to discover the full list of supported vehicles.