Bosch MDG1 ECU Tuning and Remapping Software for Ford USA

OBD Connection for Ford Vehicles

Version 7.34.0.0 of Flex has just launched, featuring OBD programming support for a variety of Bosch control units found in Ford vehicles, including: MG1CS060, MG1CS055, MG1CS040, and MD1CP062.

This exciting update allows you to retrieve ECU calibration data in just minutes, directly from the vehicle’s diagnostic socket. Say goodbye to complex procedures and invasive interventions!

Thanks to this enhancement, optimizing the engine map area becomes straightforward and efficient. You can boost performance, enhance the vehicle’s responsiveness, and reduce fuel consumption rapidly and accurately.

Supported Vehicles

Discover the impressive range of Ford models that benefit from this advanced OBD connection:

• Ford F-150 XIV 3.5L 450PS

• Ford F-250 Super Duty V 6.8L 400PS

• Ford F-650 Super Duty VIII 6.7L V8 330PS

• Ford Bronco VI 2.3L EcoBoost 280PS

• Volkswagen Amarok II 2.3L TSI

Check all supported vehicles

This new protocol is available for the following software packages:

OBD

• FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master

• FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave

• FLS0.5M – SW Flex Full Master

• FLS0.5S – SW Flex Full Slave

Buy Software

Newly Added Protocols:

OBD

• Ford Bosch MD1CP062 TC389 Read/Write/Checksum Calculation Maps

• Ford Bosch MG1CS040 TC399 Read/Write/Checksum Calculation Maps

• Ford Bosch MG1CS055 (beta) TC389 Read/Write/Checksum Calculation Maps

• Ford Bosch MG1CS060 TC387 Read/Write/Checksum Calculation Maps

Writing Time

~4 minutes

Reading Time

~6 minutes

With the versatility and efficiency of the Flex software, you can enhance your tuning process using cutting-edge automotive software tools. Whether you aim for optimal ECU and TCU remapping or performance tuning, seize this opportunity while it lasts! {exclusive deal available now}