New Boot Solution for Marelli 11GF

Version 7.13.0.0 of Flex Out Now with a New Solution for Marelli 11GF

The list of protocols supported by Flex is now even more impressive, featuring a robust Boot solution specifically designed for Marelli 11GF engine units.

With this latest update, seamlessly program FCA engine control units equipped with mild hybrid engines. This innovative solution makes tuning your engine unit simpler than ever, enhancing your vehicle’s performance while allowing for straightforward ECU restoration and cloning processes. Just read the full backup from the damaged control unit and transfer its content to the functional one without needing both vehicles present in your workshop.

Some of the Supported Vehicles:

• Fiat Panda Mild Hybrid 1.0L FireFly 70PS – 2020
• Fiat 500 Mild Hybrid 1.0L FireFly 70PS – 2020
• Lancia Ypsilon Mild Hybrid 1.0L FireFly 70PS – 2020

This New Protocol is Available for the Following Software Packages:

Boot

• FLS0.5M – SW Flex Full Master
• FLS0.5S – SW Flex Full Slave
• FLS0.10M – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Master
• FLS0.10S – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Slave

Newly Added Protocols:

(Boot)

• FCA Marelli 11GF TC277 Reading / Writing / Checksum Internal Flash; Reading / Writing Internal EEPROM; Full Backup / Clone

Reading Time: ~ 50 seconds Writing Time: ~ 40 seconds

Bug Fixes

• Added new CRC type for PSA Delphi DCM7.1AP
• Added new CRC type for Kia/Hyundai Kefico CPEG2.20.3
• Added new CRC type for Subaru Denso SH72531
• Added new CRC type for FCA Bosch ME7.9.10
• Added new CRC block for Ford Bosch MG1CS036
• Added new CRC type for Mercedes Continental ACM2.1

Software Improvements

• Added OBD Full/Bench/Boot Support for Vitesco M4C
• Added OBD Support for Nissan Hitachi BED508
• Added OBD Support for Nissan Hitachi A56-XXX
• Added Bench Support for Suzuki Bosch ME17.9.64 (2021)

Discover the full list of supported vehicles here!